Hilian Engineering

Our Gorilla Stand is a safe way to support your car while the wheels are removed. Conventional Axle Stands have always had many drawbacks - Difficult to place under a car without hitting undertrays, alloy suspension parts, virtually impossible to get full contact for safety, unstable on uneven ground, small contact points with the ground so can sink if used on soft surface, you have to get low down to see where you can put the axle stand etc etc!

Our Gorilla Stands have been independently load tested to 12.26Tonnes and each stand has a SWL 3.25Tonnes! They fit directly onto the hub after the wheels been removed which takes a couple of minutes - similar to an F1 pitstop!!
They can fit any stud pattern from 4 x 100 to 5 x 130PCD (Porsche, Audi Q7 etc), however, due to the placement of the callipers, some interfere with the safe fitment of the stand and some cars have ‘half threaded wheel bolt’s’ and extra support for vehicles which might be on very slight slopes, or the surface is overly rough which could interfere with the stand being allowed to move out while the vehicles being slowly let down - We’ve some optional extras to reduce the impact with our spacers, full threaded bolts and extra support strengthening washer.